Fujitsu PRIMERGY RX4770 M5 - Page 288

▶
"Installing the riser module 3/4 and 6/7" on page
62.
▶
"Installing the fan cage" on page 71.
▶
Install the air duct on the top system board, see "Installing the CPU air duct"
on page 74.
▶
"Reassembling" on page 53.
▶
"Installing the server in the rack" on page 55.
For CPU 3 and 4 (top system board)
▶
Install the air duct on the top system board, see "Installing the CPU air duct"
on page 74.
▶
"Reassembling" on page 53.
Further concluding steps for both installation steps:
▶
"Connecting the power cord (AC PSU)" on page 58.
▶
"Switching on the server" on page 59.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server
.
●
As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
"Resetting the error status after replacing memory modules or CPU" on
page
97.
▶
"Enabling replaced components in the BIOS" on page 102.
Processor (CPU)
288 Upgrade and Maintenance Manual RX4770 M5