Field Description
The function is enabled by default.
ARP Processing Select whether the ARP processing function should be enabled.
The ARP data traffic is reduced in the network by the fact that
ARP broadcasts that have been converted to ARP unicasts are
forwarded to IP addresses that are known internally. Unicasts
are quicker and clients with an enabled power save function are
not addressed.
The function is activated by choosing Enabled.
The function is disabled by default.
Make sure that ARP processing cannot be applied in conjunc-
tion with the MAC bridge function.
WMM Select whether voice or video prioritisation via WMM (Wireless
Multimedia) is to be activated for the wireless network so that
optimum transmission quality is always achieved for time-critical
applications. Data prioritisation is supported in accordance with
DSCP (Differentiated Services Code Point) or IEEE802.1d.
The function is activated by choosing Enabled.
The function is enabled by default.
Fields in the Virtual Service Sets Security Settings menu
Field Description
Security Mode Select the security mode (encryption and authentication) for the
wireless network.
Possible values:
• Inactive (default value): Neither encryption nor authentica-
tion
• WEP 40: WEP 40 Bit
• WEP 104: WEP 104 Bit
• WPA-PSK: WPA Preshared Key
• WPA-Enterprise: 802.11i/TKIP
Transmit Key Only if Security Mode = WEP 40, WEP 104
11 Wireless LAN Funkwerk Enterprise Communications GmbH
158 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
