Note
When setting up a bridge link, make sure that no obstacles or trees protrude into the
Fresnel zone. If obstacles exist, the transmission rate will drop and the path may even-
tually fail.
It is not essential to consider the LOS for short distances inside buildings, as the radius
of the Fresnel zone will be very small here.
If you meet these requirements, the link can be set up and maintained without further
limitations. A special feature of links with bintec bridges is that they are completely un-
affected by weather conditions.
Note
For a bridge path, always use the marked antenna connection. This is the device's
primary connection.
Fig. 75: Antenna connection
A label containing details of the two antennas is located on the back of the device. The
primary antenna is designated Ant 1.
11.1.5.1 Bridge Links->New/
Choose the icon to edit existing entries. Choose the New button to configure other
bridge links.
11 Wireless LAN Funkwerk Enterprise Communications GmbH
172 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
