other routes that are not listed is still allowed.
• You explicitly activate the import or export of certain routes. In this case, you must also
explicitly deactivate the import or export of all other routes. You can do this using a filter
for IP Address = no entry (this corresponds to the IP address 0.0.0.0) with Netmask =
no entry (this corresponds to the netmask 0.0.0.0). To make sure this filter is used last, it
must be placed at the lowest position.
You configure a filter for a default route with the following values:
• IP Address = no entry (this corresponds to the IP address 0.0.0.0) with Netmask =
255.255.255.255
In the Routing -> RIP -> RIP Filters menu, a list of all RIP filters is shown.
Fig. 86: Routing ->RIP->RIP Filter
You can use the button to insert another filter above the list entry. The configuration
menu for creating a new window opens.
You can use the button to move the list entry. A dialog box opens, in which you can se-
lect the position to which the filter is to be moved.
12.3.2.1 New
Choose the New button to set up more RIP filters.
Funkwerk Enterprise Communications GmbH
12 Routing
bintec W1002/W1002n/W2002/WIx040/WIx065 193
To Next Page
Loading...
Need help?
General
