Field Description
• Metric: The lower the value, the higher the priority of the
route (possible values 0... 15). The default value is 1.
The Advanced Settingsmenu consists of the following fields:
Fields in the menu Advanced Settings
Field Description
Block after Connection
Failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is 60.
Maximum Number of Di-
alup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are 0 to 100.
The default value is 5.
Authentication Select the authentication protocol for this connection partner.
Select the authentication specified by your provider.
Possible values:
• PAP (default value) Only run PAP (PPP Password Authentica-
tion Protocol); the password is transferred unencrypted.
• CHAP: Only run CHAP (PPP Challenge Handshake Authentic-
ation Protocol as per RFC 1994); the password is transferred
encrypted.
• PAP/CHAP: Primarily run CHAP, otherwise PAP.
• MS-CHAPv1: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• PAP/CHAP/MS-CHAP : Primarily run CHAP, on denial then
the authentication protocol required by the connection partner.
(MSCHAP version 1 or 2 possible.)
• MS-CHAPv2: Run MS-CHAP version 2 only.
DNS Negotiation Select whether your device receives IP addresses for primary
DNS server and secondary DNS server from the connection
partner or sends these to the connection partner.
The function is activated with Enabled.
13 WAN Funkwerk Enterprise Communications GmbH
214 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
