Field Description
The default value is 300.
Example: 10 for FTP transmission, 20 for LAN-to-LAN transmis-
sion, 90 for Internet connections.
Fields in the PPPoEIP Mode and Routes menu
Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• Get IP Address (default value): Your device is dynamic-
ally assigned an IP address.
• Static: You enter a static IP address.
Default Route Select whether the route to this connection partner is to be
defined as the default route.
The function is activated with Enabled.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is activated with Enabled.
The function is enabled by default.
Local IP Address Only if IP Address Mode = Static
Enter the static IP address of the connection partner.
Route Entries Only if IP Address Mode = Static
Define other routing entries for this connection partner.
Add a new entry with Add.
• Remote IP Address: IP address of the destination host or
network.
• Netmask: Netmask of Remote IP Address. If no entry is
made, your device uses a default netmask.
Funkwerk Enterprise Communications GmbH
13 WAN
bintec W1002/W1002n/W2002/WIx040/WIx065 213