Field Description
Phase-2 Profile For phase 2, select a profile already configured in the Phase-2
Profiles menu. You can also select the profile marked as the
default in Phase-2 Profiles: None (use Default
Profile).
Start mode Select how the peer is to be switched to the active state.
Possible values:
• On demand (default value): The peer is switched to the active
state by a trigger.
• Always on: The peer is always active.
Fields in the Advanced Settings Advanced IP Options menu
Field Description
Back Route Verify Select whether a check on the back route should be activated
for the interface to the connection partner.
The function is activated with Enabled.
The function is disabled by default.
Proxy ARP Select whether your device is to respond to ARP requests from
its own LAN on behalf of the specific connection partner.
Possible values:
• Off (default value) Deactivates Proxy ARP for this IPSec
peer.
• Up or Dormant: Your device only responds to an ARP re-
quest if the status of the connection to the IPSec peer is Up
(active) or Dormant. In the case of Dormant, your device
only responds to the ARP request; the connection is not set
up until someone actually wants to use the route.
• Active Only: Your device responds to an ARP request only
if the status of the connection to the IPSec peer is Up (active),
i.e. a connection already exists to the IPSec peer.
14 VPN Funkwerk Enterprise Communications GmbH
226 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
