Field Description
activated.
IPSec Debug Level Select the priority of the syslog messages of the IPSec subsys-
tem to be recorded internally.
Possible values:
• Emergency (highest priority)
• Alert
• Critical
• Error
• Warning
• Alert
• Information
• Debug (default value, lowest priority)
Syslog messages are only recorded internally if they have a
higher or identical priority to that indicated, i.e. all messages
generated are recorded at syslog level debug.
The Advanced Settings menu is for adapting certain functions and features to the special
requirements of your environment, i.e. mostly interoperability flags are set. The default val-
ues are globally valid and enable your system to work correctly to other bintec devices, so
that you only need to change these values if the remote terminal is a third-party product or
you know special settings are necessary. These may be needed, for example, if the remote
end operates with older IPSec implementations.
The Advanced Settingsmenu consists of the following fields:
Fields in the menu Advanced Settings
Field Description
Send Initial Contact
Message
Select whether IKE Initial Contact messages are to be sent dur-
ing IKE (phase 1) if no SAs with a peer exist.
The function is activated with Enabled.
The function is enabled by default.
Sync SAs with ISP inter-
face state
Select whether all SAs are to be deleted whose data traffic was
routed via an interface on which the status has changed from
Upto Down, Dormant or Blocked.
Funkwerk Enterprise Communications GmbH
14 VPN
bintec W1002/W1002n/W2002/WIx040/WIx065 241
To Next Page
Loading...
Need help?
General
