Field Description
• Static (default value): You enter a static IP address.
• Provide IP Address: Your device dynamically assigns an
IP address to the remote terminal.
Default Route Only if IP Address Mode = Static
Select whether the route to this connection partner is to be
defined as the default route.
The function is activated with Enabled.
The function is disabled by default.
Create NAT Policy
Only if IP Address Mode = Static
When you configure an ISDN connection, specify whether Net-
work Address Translation (NAT) is to be enabled.
The function is activated with Enabled.
The function is disabled by default.
Local IP Address Only for IP Address Mode = Static
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Route Entries
Only if IP Address Mode = Static
Define routing entries for this connection partner.
• Remote IP Address: IP address of the destination host or
LAN.
• Netmask: Netmask of Remote IP Address.
• Metric: The lower the value, the higher the priority of the
route (possible values 0...15). The default value is 1.
IP Assignment Pool
(IPCP)
Only if IP Address Mode = Provide IP Address
Select an IP pool.
The Advanced Settingsmenu consists of the following fields:
Fields in the menu Advanced Settings
Funkwerk Enterprise Communications GmbH
14 VPN
bintec W1002/W1002n/W2002/WIx040/WIx065 257
To Next Page
Loading...
Need help?
General
