13
CONTENTS AND TECHNICAL SPECIFICATIONS
(Specications and ratings are subject to change without notice.)
Your 10J includes the following components:
SYSTEM COMPATIBILITY
• T10J transmitter for airplanes or helicopters
• R3008SB Receiver
• Switch harness
• Neck strap
*The set contents depend on the type of set.
Transmitter T10J
(2-stick, 10-channel, T-FHSS Air-2.4G system)
Transmitting frequency: 2.4GHz band
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V Dry battery
Receiver R3008SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS system)
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)
Weight: 0.36 oz. (10.1g)
Battery F/S Voltage: It sets up with a transmitter
(*1) When using ESC's make sure that the regulated output capacity meets your usage application.
●EXT battery terminal
The voltage can be displayed at the transmitter by branch connecting the drive battery, etc. installed in
the fuselage with the CA-RVIN-700 cable sold separately.
●Battery fail safe function
The
10J
is a
2.4GHz T-FHSS Air system
. The transmitter can also be switched to
S-FHSS
. (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
NOTE：
*The Futaba
T-FHSS Air
system cannot be used with Futaba
S-FHSS/FASST/FASSTest
systems. Use
it with a
T-FHSS Air
system transmitter and receiver. The
T10J
is a
T-FHSS Air system
, but can also
be used with an
S-FHSS
receiver by switching to
S-FHSS
. However, in this case the telemetry system
cannot be used.
*The
T-FHSS Air system
and
T-FHSS
surface system are different. The
T10J
cannot be used with the
R304SB, R304SB-E
or
T-FHSS
surface system receivers.
Communications System
Usable Receivers
T-FHSS Air
（Default）
R3008SB
*R304SB, R304SB-E, T-FHSS surface system
receivers do not operate.
S-FHSS
（Change is possible）
R2008SB
R2006GS
R2106GF
To Next Page
Loading...
