FUTABA T10J Manual

50
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
END POINT 1 2
CH1 : AIL
1: AIL
2: ELE
3: THR
4: RUD
5: GER
100 /100
100 /100
100 /100
100 /100
100 /100
100 100
← →
→
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
●The servo travel can be adjusted individually at
the left and right sides.
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5 to 10.
However, the maximum servo travel for channels 5 to 10 is
about 110%.
*When channels 5 to 8 were mixed by aperon, di󱐯erential or
ailvator, the throw becomes the same (about 40° ) as channels
1 to 4.
"END POINT"
● Select the channel with
the Jog key.
● The setting rate of each
channel
（Left ／ Down）
rate display
（Right ／ Up）
rate display
END POINT
End point
(Common)
① A channel is chosen by Jog key.
Selection range：1 〜 10ch
② Operate the stick or knob of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
– key.
or
Range：
0 〜 140%
Default：100%
● When you want to
return the set value
to the initial value,
press the + key and –
key simultaneously.
Adjust the rate of each direction of the stick and VR by repeating step ① .
End point
＜ ChannelDisplay ＞
ACROBATIC HELICOPTER GLIDER (AF4) MULTICOPTER
1: AIL（Aileron） 6: FLP（Flap）1: AIL（Aileron） 6: PIT（PITCH）1: AIL（Aileron） 6: FL2（Flap2） 1: AIL（Aileron） 6: AUX
2: ELE（Elevator）7: AUX 2: ELE（Elevator）7: AUX 2: ELE（Elevator）7: AL2（Aileron2）2: ELE（Elevator）7: AUX
3: THR（Throttle）8: AUX 3: THR（Throttle）8: AUX 3: MOT（Motor） 8: FL3（Flap3） 3: THR（Throttle）8: AUX
4: RUD（Rudder）9: AUX 4: RUD（Rudder）9: AUX 4: RUD（Rudder）9: FL4（Flap4） 4: RUD（Rudder）9: AUX
5: GER（Gear） 10: AUX 5: GYR（GYRO） 10: AUX 5: FLP（Flap） 10: AUX 5: MOD 10: AUX
＋
－

FUTABA T10J Specifications

General

Channels	10
Frequency	2.4GHz
Model Memory	30
Display	LCD
Telemetry	Yes
Weight	590g
Trainer Port	Yes
Modulation	S-FHSS
Power Supply	6V to 7.4V (2S LiPo)