FUTABA T10J - Parameter

58
Common function
Function
PARAMETER submenu: sets those parameters
you would likely set once, and then not disturb
again.
Once you have selected the correct model you
wish to work with, the next step is setting up the
proper parameters for this specic model:
Data reset （RESET）
The present model data is reset. Data Reset does NOT reset, ATL Trim, TELEMETRY mode, or STK POSI
Alarm.
Model type（TYPE） SWASH : Only helicopter WING : Only glider
MODEL TYPE: sets the type of programming used for this model.
The T10J has 30 model memories, which can each support:
●
One powered aircraft (ACRO) memory type (with multiple wing and tail congurations. See twin
aileron servos, twin elevator servos, ELEVON, and V-TAIL for further information.)
●
Eight helicopter swashplate types, including CCPM. See Helicopter MODEL TYPE for details.
● If you use CGY750, the swash type should choose H-1. ( Swash type is chosen by setup in CGY750. ）
●
Five glider wing types. See glider WING TYPE for details.
●
Multicopter type.
Before doing anything else to set up your aircraft, rst you must decide which MODEL TYPE best ts
this particular aircraft. (Each model memory may be set to a di󱐯erent model type.) If your transmitter
is a T10JA, the default is ACRO. If it is a T10JH, the default is HELI(H1).
ATL Trim（ATL）
Adjustable travel limit (ATL): makes the channel 3 TRIM LEVER (THROTTLE TRIM) e󱐯ective only at
low throttle, disabling the trim at high throttle. This prevents pushrod jamming due to idling trim
changes. This function defaults to ON. If you are not using channel 3 for throttle, you may want
trim operation the same as on all other channels. To do so, set ATL to OFF. If you need the ATL to be
e󱐯ective at the top of the stick instead of the bottom, reverse the THR-REV setting. Note that this
a󱐯ects all models in the radio, not just the model you are currently editing.
LCD contrast（CONTRAST）
Contrast adjustment LCD screen.
● You adjust to legible contrast. set up range -10 〜 +10
Back light（BACK-LIT）
Back light mode of a LCD screen can be chosen.
● ALWAYS / KEY-ON (Shines for a denite period of time after key operation.) / OFF
Light time（LIT-TIME）
Sets the length of time the backlight will stay on.
● Set up range 1 〜 30
Light adjustment（LIT-ADJS）
Light volume adjustment of a back light.
● Set up range 1 〜 30
Home display （HOME-DSP）
Item selection displayed on a home screen
● Futaba logo (Default), USR-NAME , RX BATT, DT5/DT6, THR/PIT (Case of helicopter, the position of a
throttle and pitch.)
PARAMETER
Parameter function
(Common)