FUTABA T10J - TX SETTING - System Configuration; Stick Mode and Calibration

175
■ THR-REV
■ LANGUAGE
This function is not used. When you want to use full throttle with the throttle stick down
and slow with the throttle stick up, select REV. When the stick is up, trim is e󱐯ective and
when the stick is down, trim is not e󱐯ective.
*Throttle servo operation reversed by the linkage is usually performed by reverse in the
normal menu. When throttle servo operation is reversed with the THR-REV function, trim
becomes ine󱐯ective at slow.
The language displayed at proportional can be changed. The initial setting is Japanese,
but can be selected from among 7 languages.
Return from the transmitter setting screen to the normal menu by turning on the power
without pressing a key.
④ Swing the selected stick fully
to the left and right (up and
down).
⑤ ■ appears next to "LEFT"
and "RGHT". Press the Jog
key.
⑥ When "COMPLETE" i s
displayed, adjustment is
complete.
END
① Turn off the power and then
turn on the power while
pressing the + key and – key
simultaneously.
② Select THR-REV → NOR
in the menu with the Jog
key.
③ Select NOR or REV b y
pressing the + key or – key.
Setting is ended by power
o󱐯.
THR-REV
＋ －
＋
－
① Turn off the power and then
turn on the power while
pressing the + key and – key
simultaneously.
② Select
LANGUAGE → English in
the menu with the Jog
key.
③ Select NOR or REV b y
pressing the + key or – key.
Setting is ended by power
o󱐯.
LANGUAGE
＋ －
＋
－
FUTABA CORPORATION
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
2014, 01 (1)