FUTABA T10J Manual

78
Common function
VARIO
(ALARM) (VIB) (LIMIT)
UP▶INH ▶OFF ▶ +50
DN▶INH ▶OFF ▶ -50
SPEECH▶ INH SW▶ NULL
0 m/s
0 / 0MIN/MAX=
VARIO is a screen which displays / sets up the
variometer information from an optional altitude
sensor or GPS sensor.
The variometer of the model which is ying can
be known.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
● Conversion of a display unit is performed by "TELEMETRY
UNIT" of "PARAMETER".
●Select [VARIO] in the TELEMETRY screen and access the
setup screen shown below by press the Jog key.
●"DN" indicates the
alarm will start when
the vario reaches
below your set value.
●"UP"indicates the alarm
will start when the
vario reaches above
your set value.
Alert set : Rise side
1. Move the cursor to the UP:(ALERT) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: +50(m/s)
Adjustment range: -150~+150(m/s)
(UP:(LIMIT)
≧
DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
Alert set : Low side
1. Move the cursor to the DN:(ALERT) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: -50(m/s)
Adjustment range: -150~+150(m/s)
(UP:(LIMIT)
≧
DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
*An altitude sensor or GPS sensor must be installed in the aircraft.
●Variometer
VARIO : Display of SBS-01A / SBS-01G(Option), and alarm setup
ON
2 Position 3 Position
OFF
ON
OFF
OFF
● Switch selection
TYPE 1
TYPE 2
TYPE 3
"VIB" type
If the following types are selected, the
transmitter will vibrate during the warning.
●You can hear the
Vario data through an
earphone or headset,
by Activating the Speech
function.
●The maximum and the minimum
when powering ON are shown.
● Maximum and minimum
date reset by
pressing the Jog key for 1 second.

FUTABA T10J Specifications

General

Channels	10
Frequency	2.4GHz
Model Memory	30
Display	LCD
Telemetry	Yes
Weight	590g
Trainer Port	Yes
Modulation	S-FHSS
Power Supply	6V to 7.4V (2S LiPo)