FUTABA T10J - Date Reset

60
Common function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
① Call the "RESET" from the PARAMETER by Press
the Jog key for 1 second.
（1 second）
● Conrmation message "sure?" blinks.
② Date reset by pressing the Jog key.
● A confirmation "beep" sounds and
"COMPLETE" is displayed on the screen is
complete.
For safety, a double setting system is used. You need to conrm your setting changes by pressing the
jog key. When "COMPLETE" can be seen, it is the completion of reset.
Date reset
Only the throttle channel (CH3) initial setting is REV (reverse). Thoroughly check the Hi and Low directions
of the engine or motor used and be careful that they do not suddenly run at full speed. Even after data reset,
CH3 is reversed.
CAUTION
● Next page 2 〜 5
page 1
page 2
page 3
page 4
page 5
"PARAMETER"
PARAMETER 1 2 3 4 5
TYPE▶ ACROBATIC
ATL▶ ON (MDL)
RESET▶ Execute
Data reset
Model type
Swash type
Wing type
ATLTrim
(In the case of a helicopter )
(In the case of a glider )
LCD contrast（CONTRAST）
Back light（BACK-LIT）
Light time（LIT-TIME）
Light adjustment（LIT-ADJS）
Home display （HOME-DSP）
Battery alarm（BATT ALM）
Battery alarm vibration（BATT VIB）
Buzzer tone （BUZ-TONE）
Jog key navigation （JOG-NAVI）
Jog light（JOG-LIT）
Jog light time（JOG-TIME）
（TELEMETRY MODE）
（TELEMETRY UNIT）
（SPEECH LANGUAGE）
（SPEECH VOLUME）
Stick position alarm（STK POSI ALRM）