FUTABA T10J - Condition

122
Helicopter
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
The condition switches (idle up 1/2/3 and throttle
hold switch) are not operative at initial setting.
Switch setting is performed in advance with the
condition select function.
●Initially set to idle up 1: SwE (center), idle up 2: SwE
(forward), idle up : SwF (forward), throttle hold:
SwG (forward).
"CONDITION"
CONDITION
Condition select
(Idle-up・Throttlehold)
(HELICOPTER)
■ Activating the function
＋ －
or
① Select the "INH" item of the
condition you want to use and set
it to "ON" or "OFF" by pressing the
+ key or – key.
● Set conditions you do not want to use to "INH".
（In the case of change of a switch）
■ Switch selection
＋ －
or
② A cursor is moved to
"Switch selection" and
a switch is changed by
＋ key or － key.
Range：SwA ～ SwH
Default：SwE（IDLE-UP1/2）、
SwF（IDLE-UP3）、SwG（THR-HOLD）
■ Switch direction
＋ －
or
③ A cursor is moved to
"Switch direction" and
a switch direction is
changed by ＋ key or －
key.
Range：
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN,
DOWN
Condition select
Idle-up
setting
Throttlehold
setting
● When not using this Function
select INH. The display of On/
O󱐯 is shown when active and
assigned to a switch.
● Select the setting item
with the Jog key.
（Activating thefunction） （Switch direction ）
（Switch selection ）
CONDITION