FUTABA T10J Manual

144
Helicopter
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
The hovering pitch function trims the pitch near
the hovering point.
When the hovering pitch knob is turned
clockwise, the pitch gets stronger and when it is
turned counterclockwise, the pitch gets weaker.
Rotor speed changes due to changes in temperature,
humidity, and other flying conditions can be
trimmed. Adjust for the most stable rotor rotation.
More precise trimming is possible by using
this function together with the hovering throttle
function.
●The operating condition can be selected from
normal only and normal/idle up 1.
●The trim position can be memorized. If it is
memorized before the model memory is changed,
the original trim state can be retrieved by merely
setting the knob to the center when the trim
position is recalled.
"HOV-PIT"
HOV-PIT
Hovering pitch
(HELICOPTER)
■ Activating the function
＋ －
or
① Select the "MIX"
item and then
select the "ON" by
pressing the + key
or – key.
● When you do not use a function, set to
the "INH" side.
■ Selection of condition
＋ －
or
② Select the "MODE" item
and then select condition
by pressing the + key or –
key.
Range：NORM, NORM/IDL1
Default：NORM
■ VR setting
＋ －
or
③ Select the "VR" item
and then select the
"VR" or "DT" b y
pressing the + key
or – key.
Range：NULL（OFF）, +VR, -VR, +DT5, -DT5,
+DT6, -DT6
Default：-VR
（Memorizing the hovering pitch adjustment position）
■ Memory setting
④ Select the "RATE" item and memorize the current
trim position by pressing the Jog key.
● When the knob is returned to the center after
memorization, the trim position returns to its
previous position.
［NOTE］If memorization is repeated at the same
position, the value is cumulated.
Hovering Pitch
Activating the function
Trim memory settting
VR setting
Selection of condition
● When "INH", the function
cannot be used. To use the
function, switch to "ON".
（Compensation amount at trim
memory）
（Actual compensation amount
including the hovering pitch
knob）
● The knob operating direction
is di󱐯erent depending on the
polarity
● Select the setting item
with the Jog key.
● NORM：Only the normal condition operates
● NORM/IDL1：It operates by normal condition and
idle-up1.
HOV-PIT

FUTABA T10J Specifications

General

Channels	10
Frequency	2.4GHz
Model Memory	30
Display	LCD
Telemetry	Yes
Weight	590g
Trainer Port	Yes
Modulation	S-FHSS
Power Supply	6V to 7.4V (2S LiPo)