GE CARESCAPE ONE - Selecting HR Alarm Range; Showing Another Value in the HR Parameter Window

ECG
NOTE
Thissettingadjuststheprimaryheartratesourceforallofthe
hemodynamicparameters.
1.SelecttheHRparameterwindow.
2.SelectSetup>Page2.
3.SelectaparameterfromthePrimaryHRSourcelist.Theselectionlistwillonly
showactivemeasurementsandAUTO,IntelliRate,orECG.Choicesare:
●SingleHR:AUTO,IntelliRate,ECG,invasivepressurechannel(s)labeledArtX,
FemX,orUACXwhereX=channelnumber,Pleth(SpO2).
●MultipleHR:AUTO,IntelliRate,ECG.
FormoreinformationaboutAUTOandIntelliRate,seetheECGmeasurement
practicalitiessectioninthischapter.
SelectingHRalarmrange
WiththeSingleHRAlarmssettingonly.
1.SelecttheHRparameterwindow.
2.SelectAdvanced>Page2.
3.SelecttheheartratealarmrangefromtheHRAlarmRangelist:
●30-240(setanddisabledifthePrimaryHRSourceisIntelliRate,AUTO,or
Pleth(SpO2).)
●20-300
ShowinganothervalueintheHRparameterwindow
InadditiontotheprimaryHR,youcandisplayanothervalueintheHRparameter
window.
1.SelecttheHRparameterwindow.
2.SelectAdvanced>Page2.
3.SelectanoptiontodisplayintheHRparameterwindowfromtheShowwith
HRlist:
●ST
●PVC
●2ndHR
￭IftheprimaryHRsourceisECG,AUTO(ECG),orIntelliRate(ECG),the
secondaryHRsourcedisplayedintheorder:primaryarterialsource(ArtX,
FemX,orUACX,whereX=channelnumber),SpO2.
￭IftheprimaryHRsourceisanythingotherthanmentionedabove,the
secondaryHRsourceisalwaysECG.
●Off
2094480-001CARESCAPEONE109
CARESCAPE ONE User Manual DRAFT 26 October 2017