91
PPPoE client commands
dialer diagnose
Use dialer diagnose to configure DDR to operate in diagnostic mode.
Use undo dialer diagnose to restore the default.
Syntax
dialer diagnose [ interval interval ]
undo dialer diagnose
Default
DDR operates in non-diagnostic mode.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
interval: Specifies the diagnostic interval in the range of 5 t o 65535 s econds. The default is 120
seconds.
Usage guidelines
This command takes effect only when a dialer interface is used with PPPoE client applications.
In diagnostic mode, the device performs the following operations:
• Dials a PPPoE connection immediately after the device configurations are complete.
• Automatically terminates the connection.
• Starts the auto-dial timer after a configurable diagnostic interval.
• Redials a connection when the auto-dial timer expires.
By establishing and terminating PPPoE sessions periodically, you can monitor the operating status
of the PPPoE link.
In diagnostic mode, the link idle-timeout timer is ignored.
Examples
# Configure Dialer 1 to operate in diagnostic mode, with a diagnostic interval of 300 seconds.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer diagnose interval 300
Related commands
dialer timer autodial
dialer timer idle
display pppoe-client session packet
Use display pppoe-client session packet to display the protocol packet statistics for a PPPoE
session.
To Next Page
Loading...
