168
Syntax
isdn carry connected-name
undo isdn carry connected-name
Default
ISDN does not include the connected-name field in outgoing packets.
Views
ISDN interface view
Predefined user roles
network-admin
Usage guidelines
The command enables a calling party to identify the name of a called party attached to the interface.
You can execute the command only when no call is present on the ISDN interface.
Examples
# Configure ISDN to include the connected-name field in outgoing packets on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn carry connected-name
Related commands
isdn carry calling-name
isdn check-called-number
Use isdn check-called-number to configure called-number verification for incoming calls on an
ISDN interface.
Use undo isdn check-called-number to remove an acceptable called number.
Syntax
isdn check-called-number check-index called-party-number
undo isdn check-called-number check-index
Default
ISDN does not check the called number or subaddress in incoming SETUP messages.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
check-index: Specifies a called-number verification index in the range of 1 to 3.
called-party-number: Specifies an acceptable called number. You can include a colon-separated
subaddress when you specify the called number, for example, 66668888:13525. The value must be
a case-sensitive string of 1 to 40 characters.
To Next Page
Loading...
