44
Physical Physical type of the interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0)
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0)
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0)
Traffic statistics of the interface output queues.
Brief information on interfaces in route
mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is operating as a backup interface. To
see the primary interface, use the display interface-backup
state command in High Availability Command Reference.
Protocol: (s) - spoofing
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Interface Abbreviated interface name.
Link
Physical link state of the interface. This field for a VT interface can
only be
DOWN
.
Protocol
Line protocol state of the interface. This field for a VT interface can
only be
DOWN
.
Primary IP Primary IP address of the interface.
Description
Interface description configured by using the
description
command. If you do not specify the
description
keyword,
the
display interface
brief
command displays a maximum of 27
characters of the description. If you specify the
description
keyword, the command displays the complete description.
Cause
Causes for the physical state of the interface to be Down.
Not connected
indicates no physical link exists (possibly because
the network cable is disconnected or faulty).
display ppp mp
Use display ppp mp to display MP information for MP-group interfaces.
Syntax
display ppp mp [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its number. If you do not specify
this option, the command displays MP information for all interfaces.
To Next Page
Loading...
