H3C MSR810 - ATM Commands; Bandwidth; Broadcast

194
ATM commands
ATM is supported only by MSR routers installed with an ATM-OC3, ADSL2+, G.shdsl, or G.shdsl.Bis
interface module.
ATM is not supported on the MSR3600-28-SI/3600-51-SI routers.
bandwidth
Use bandwidth to configure the expected bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
VE interface view
VE subinterface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth of an interface affects the link costs of IS-IS, OSPF, and OSPFv3. For more
information, see Layer 3—IP Routing Configuration Guides.
Examples
# Set the expected bandwidth of Virtual-Ethernet 2/4/1 to 50 kbps.
<Sysname> system-view
[Sysname] interface virtual-ethernet 2/4/1
[Sysname-Virtual-Ethernet2/4/1] bandwidth 50
broadcast
Use broadcast to enable the broadcast attribute for a PVC or PVC-group.
Use undo broadcast to disable the broadcast attribute for a PVC or PVC-group.
Syntax
broadcast
undo broadcast
Default
The broadcast attribute is disabled.