H3C MSR810 - Service Standby

63
# (Centralized devices in IRF mode.) Specify slot 2 as the primary traffic processing slot for VA
interfaces on Virtual-Template 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] service slot 2
# (Distributed devices in IRF mode.) Specify slot 2 as the primary traffic processing slot for VA
interfaces on Virtual-Template 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] service chassis 2 slot 2
Related commands
service standby
service standby
Use service standby to specify a backup traffic processing slot for an interface.
Use undo service standby to restore the default.
Syntax
Distributed devices in standalone mode/centralized devices in IRF mode:
service standby slot slot-number
undo service standby slot
Distributed devices in IRF mode:
service standby chassis chassis-number slot slot-number
undo service standby chassis
Default
No backup traffic processing slot is specified for an interface.
Views
VT interface view
Default command level
network-admin
Parameters
slot slot-number: Specifies a card by its slot number. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. (Centralized devices in IRF
mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device.
The chassis-number argument represents the member ID of the IRF member device.
The slot-number argument represents the slot number of the card. (Distributed devices in IRF
mode.)
Usage guidelines
The following matrix shows the command and hardware compatibility: