198
display atm pvc-group
Use display atm pvc-group to display PVC-group information.
Syntax
display atm pvc-group [ interface interface-type { interface-number
| interface-number.subnumber } [ pvc-group group-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type { interface-number | interface-number.subnumber }: Specifies an interface
by its type and number. Both ATM interfaces and ATM subinterfaces are supported.
pvc-group group-number: Specifies a PVC-group by its number in the range of 1 to 128.
Usage guidelines
If you do not specify an ATM interface, this command displays brief information about all PVC-groups
on all ATM interfaces.
If you specify an ATM interface but do not specify a PVC-group, this command displays brief
information about all PVC-groups on the specified ATM interface.
If you specify an ATM interface and a PVC-group, this command displays detailed information about
the specified PVC-group.
Examples
# Display brief information about all PVC-groups on all ATM interfaces.
<Sysname> display atm pvc-group
ATM2/4/0, State UP
PVC-group: 1
Encapsulation: SNAP, Protocol: IP
VPI/VCI PVC name Precedence State
1/32 aa Default UP
2/32 N/A 2-3 UP
3/32 N/A 5 UP
PVC-group: 3
Encapsulation: SNAP, Protocol: IP
VPI/VCI PVC name Precedence State
3/64 bb 4 UP
4/64
N/A Default UP
ATM2/4/1, State UP
PVC-group: 1
Encapsulation: SNAP, Protocol: IP
VPI/VCI PVC name Precedence State
1/32 aa Default UP
To Next Page
Loading...
