H3C MSR810 - Pppoe-Server Session-Limit Per-Vlan

83
PPPoE can establish a session when none of the following limits are reached:
• Limit for a user on an interface.
• Limit for a VLAN on an interface.
• Limit on an interface.
• Limit on a card. (Distributed devices in standalone.)
• Limit on a device. (Centralized devices in standalone mode.)
New maximum number settings only apply to subsequently established PPPoE sessions.
Examples
# Set the maximum number of PPPoE sessions for a user on GigabitEthernet 1/0/1 to 50.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server session-limit per-mac 50
Related commands
pppoe-server session-limit
pppoe-server session-limit per-vlan
pppoe-server session-limit total
pppoe-server session-limit per-vlan
Use pppoe-server session-limit per-vlan to set the maximum number of PPPoE sessions for a
VLAN on an interface.
Use undo pppoe-server session-limit per-vlan to restore the default.
Syntax
pppoe-server session-limit per-vlan number
undo pppoe-server session-limit per-vlan
Default
The number of PPPoE sessions for a VLAN on an interface is not limited.
Views
Layer 3 Ethernet subinterface view
Layer 3 virtual Ethernet subinterface view
Layer 3 aggregate subinterface view
VE-L3VPN subinterface view
EFM subinterface view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of PPPoE sessions for a VLAN, in the range of 1 to 65534.
Usage guidelines
PPPoE can establish a session when none of the following limits are reached:
• Limit for a user on an interface.
• Limit for a VLAN on an interface.