H3C MSR810 - Oam Loopback

215
down down-seconds: Specifies the time (in seconds) within which the PVC goes down if it receives
successive AIS/RDI alarm cells. The value range for the down-seconds argument is 1 to 60 seconds.
Usage guidelines
The system uses a 1-second timer to detect AIS/RDI alarm cells.
• A PVC goes down if it receives successive AIS/RDI alarm cells in the time period specified by
the
down-seconds argument.
• A PVC comes up if no AIS/RDI alarm cells are received in the time period specified by
the
up-seconds argument.
Examples
# Configure the AIS/RDI alarm detection parameters for PVC 1/32, setting up-seconds to 5
and down-seconds to 5.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/32
[Sysname-ATM2/4/0-pvc-1/32] oam ais-rdi up 5 down 5
# Configure the AIS/RDI alarm detection parameters for PVC 1/33 of PVC-group 2,
setting up-seconds to 5 and down-seconds to 5.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc-group 2
[Sysname-ATM2/4/0-pvc-group-2] pvc 1/33
[Sysname-ATM2/4/0-pvc-group-2-pvc-1/33] oam ais-rdi up 5 down 5
oam loopback
Use oam loopback to enable OAM F5 Loopback cell transmission and retransmission detection and
modify related parameters.
Use undo oam loopback to disable OAM F5 Loopback cell transmission and retransmission
detection.
Syntax
oam loopback interval [ up up-count down down-count retry retries ]
undo oam loopback
Default
OAM F5 Loopback cell transmission is disabled. Responses are sent if OAM F5 Loopback cells are
received.
Views
PVC view
PVC view in a PVC-group
Predefined user roles
network-admin
Parameters
interval: Specifies the interval for sending OAM F5 Loopback cells, in the range of 1 to 600 seconds.
up up-count: Specifies the number of successive OAM F5 Loopback cells received before the PVC
comes up. The value range for the up-count argument is 1 to 600, and the default is 3.