190
Default
No SPID or LDN is configured for the B1 channel on an NI-enabled BRI interface.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Parameters
spid: Sets a SPID, a string of 1 to 20 digits.
ldn: Sets a local dialing number, a string of 1 to 30 digits.
Usage guidelines
The command is available only on NI-enabled BRI interfaces.
When you use the command, follow these guidelines:
• Make sure the configured SPID is the same as the SPID assigned by the service provider.
• Configure an LDN depending on the service provider requirement. If an LDN is configured, the
setting for the
isdn calling command becomes invalid.
• You cannot configure a SPID in the following situations:
A call is present.
A SPID negotiation is present.
Examples
# Assign a SPID of 012345 and an LDN of 54321 to the B1 channel on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn spid1 012345 54321
Related commands
isdn calling
isdn spid2
isdn spid2
Use isdn spid2 to assign a SPID to the B2 channel on an NI-enabled BRI interface.
Use undo isdn spid2 to restore the default.
Syntax
isdn spid2 spid [ ldn ]
undo isdn spid2
Default
No SPID or LDN is configured for the B2 channel on an NI-enabled BRI interface.
Views
ISDN BRI interface view
Predefined user roles
network-admin
To Next Page
Loading...
