309
Description Description of the interface.
Cause
Reason why a physical link is down. If the port has been shut down by
using the
shutdown
command, this field displays
Administratively
. To
restore the physical state of the interface, use the
undo shutdown
command.
Not connected
indicates no physical connection due to
absence or failure of a network cable.
Related commands
reset counters interface
interface dialer
Use interface dialer to create a dialer interface and enter its view, or enter the view of an existing
dialer interface.
Use undo interface dialer to delete a dialer interface.
Syntax
interface dialer number
undo interface dialer number
Default
No dialer interface exists.
Views
System view
Predefined user roles
network-admin
Parameters
number: Specifies the number of the dialer interface, in the range of 0 to 1023.
Usage guidelines
A dialer interface has a fixed baud rate of 64000 bps.
Examples
# Create Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
mtu
Use mtu to set the maximum transmission unit (MTU) of a dialer interface.
Use undo mtu to restore the default.
Syntax
mtu size
undo mtu
Default
The MTU of dialer interfaces is 1500 bytes.
To Next Page
Loading...
