82
Usage guidelines
PPPoE can establish a session when none of the following limits are reached:
• Limit for a user on an interface.
• Limit for a VLAN on an interface.
• Limit on an interface.
• Limit on a card. (Distributed devices in standalone.)
• Limit on a device. (Centralized devices in standalone mode.)
New maximum number settings only apply to subsequently established PPPoE sessions.
Examples
# Set the maximum number of PPPoE sessions on GigabitEthernet 1/0/1 to 50.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server session-limit 50
Related commands
pppoe-server session-limit per-mac
pppoe-server session-limit per-vlan
pppoe-server session-limit total
pppoe-server session-limit per-mac
Use pppoe-server session-limit per-mac to set the maximum number of PPPoE sessions for a
user on an interface.
Use undo pppoe-server session-limit per-mac to restore the default.
Syntax
pppoe-server session-limit per-mac number
undo pppoe-server session-limit per-mac
Default
A user can create a maximum of 100 PPPoE sessions on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of PPPoE sessions for a user, in the range of 1 to 65534.
Usage guidelines
A user is identified by a MAC address.
To Next Page
Loading...
