H3C MSR810 - Display Fr Map

329
fr lmi n392dce
fr lmi n392dte
fr lmi n393dce
fr lmi n393dte
fr lmi t392dce
fr lmi type
timer-hold
display fr map
Use display fr map to display Frame Relay address mapping.
Syntax
display fr map [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main or subinterface. If you specify a main interface, this command displays information for the main
interface and its subinterfaces. If you specify a subinterface, this command displays information for
the subinterface. If you do not specify an i nterface, this command displays information for all
interfaces.
Usage guidelines
Based on the output from this command, you can determine whether the static address-to-DLCI
maps are correct and whether dynamic address mapping is operating correctly.
Examples
# Display Frame Relay address mapping for all interfaces.
<Sysname> display fr map
Map information for interface Serial2/1/0 (DTE)
DLCI: 100, IP InARP 100.100.1.1, Serial2/1/0
Creation time: 2012/10/21 14:48:44, Status: Active
DLCI: 200, IP InARP 100.100.1.1, Serial2/1/0
Creation time: 2012/10/21 14:34:42, Status: Active
DLCI: 300, IP 1.1.1.1, Serial2/1/0
Creation time: 2012/10/21 15:03:35, Status: Active
Table 65 Command output
Field
Description
Map information for interface Serial2/1/0 (DTE)
Frame Relay address mapping for DTE interface
Serial 2/1/0.