312
If you specify a dialer interface, this command clears statistics for the specified dialer interface.
Examples
# Clear the statistics of Dialer 1.
<Sysname> reset counters interface dialer 1
Related commands
display interface dialer
service
Use service to specify a primary traffic processing slot for an interface.
Use undo service to restore the default.
Syntax
Distributed devices in standalone mode/centralized devices in IRF mode:
service slot slot-number
undo service slot
Distributed devices in IRF mode:
service chassis chassis-number slot slot-number
undo service chassis
Default
No primary traffic processing slot is specified for an interface
Views
Dialer interface view
Default command level
network-admin
Parameters
slot slot-number: Specifies a card by its slot number. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. (Centralized devices in IRF
mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device.
The chassis-number argument represents the member ID of the IRF member device.
The slot-number argument represents the slot number of the card. (Distributed devices in IRF
mode.)
Usage guidelines
The following matrix shows the command and hardware compatibility:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE
/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS
No
MSR2600-10-X1 No
MSR 2630 Yes
MSR3600-28/3600-51 Yes
MSR3600-28-SI/3600-51-SI No
To Next Page
Loading...
