H3C MSR810 - Ppp Pap Local-User

27
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp lqm lcp-echo packet 1400 interval 1
ppp pap local-user
Use ppp pap local-user to set the local username and password for PAP authentication on an
interface.
Use undo ppp pap local-user to restore the default.
Syntax
ppp pap local-user username password { cipher | simple } string
undo ppp pap local-user
Default
The local username and password for PAP authentication are blank on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
username: Specifies the username of the local device for PAP authentication, a case-sensitive string
of 1 to 80 characters.
cipher: Specifies a password in encrypted form.
simple: Specifies a password in plaintext form. For security purposes, the password specified in
plaintext form will be stored in encrypted form.
string: Specifies the password. Its plaintext form is a case-sensitive string of 1 to 255 characters. Its
encrypted form is a case-sensitive string of 1 to 373 characters.
Usage guidelines
For the local device to pass PAP authentication on the peer, make sure the username and password
configured for the local device are also configured on t he peer. You can configure the peer's
username and password by using the local-user username and password { cipher | simple } string
commands, respectively.
Examples
# Set the local username and password for PAP authentication to user1 and plaintext pass1 on
Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp pap local-user user1 password simple pass1
Related commands
local-user (Security Command Reference)
password (Security Command Reference)