95
Parameters
all: Resets all the PPPoE sessions.
dial-bundle-number number: Specifies a dialer bundle by its number in the range of 0 to 1023.
Usage guidelines
A PPPoE session in permanent mode and terminated by this command will be established again
when the auto dial timer expires.
A PPPoE session in on-demand mode and terminated by this command will be established again
only when there is a need for data transmission.
Examples
# Reset all PPPoE sessions.
<Sysname> reset pppoe-client all
Related commands
dialer timer autodial
reset pppoe-client session packet
Use reset pppoe-client session packet to reset the protocol packet statistics for a PPPoE session.
Syntax
reset pppoe-client session packet [ dial-bundle-number number ]
Views
User view
Predefined user roles
network-admin
Parameters
dial-bundle-number number: Specifies the dialer bundle number corresponding to a P PPoE
session, in the range of 0 to 1023. If you do not specify this option, the command resets the protocol
packet statistics for all PPPoE sessions.
Examples
# Reset the protocol packet statistics for all PPPoE sessions.
<Sysname> reset pppoe-client session packet
Related commands
display pppoe-client session packet
To Next Page
Loading...
