289
Use undo dialer bundle-member to remove a physical interface from a dialer bundle in bundle
DDR.
Syntax
dialer bundle-member number [ priority priority ]
undo dialer bundle-member number
Default
A physical interface does not belong to any dialer bundle in bundle DDR.
Views
Physical interface view
Predefined user roles
network-admin
Parameters
number: Specifies a dialer bundle by its number, which must be the same as the dialer interface
number.
priority priority: Specifies the priority of the physical interface in the dialer bundle, in the range of 1 to
255. The default priority is 1. The greater the number, the higher the priority. Each time a call is
placed, the highest-priority physical interface available is selected. If multiple physical interfaces with
the highest priority are available, these interfaces are selected in a round-robin manner.
Usage guidelines
A physical interface can belong to multiple dialer bundles. You can configure this command multiple
times to assign a physical interface to different dialer bundles.
When the specified dialer interface does not exist, this command creates one and enables bundle
DDR on it.
Examples
# Assign BRI 2/4/0 to Dialer bundle 1 and Dialer bundle 2, with a priority of 50 in both dialer bundles.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] dialer bundle-member 1 priority 50
[Sysname-Bri2/4/0] dialer bundle-member 2 priority 50
Related commands
dialer bundle enable
interface dialer
dialer callback-center
Use dialer callback-center to configure the PPP callback reference.
Use undo dialer callback-center to restore the default.
Syntax
dialer callback-center [ dial-number | user ] *
undo dialer callback-center
Default
No PPP callback reference is configured.
To Next Page
Loading...
