EasyManua.ls Logo

H3C MSR810 - Shutdown

H3C MSR810
389 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
152
Hardware
Command compatibility
MSR3600-28-SI/3600-51-SI No
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC Yes
MSR 3610/3620/3620-DP/3640/3660 Yes
MSR5620/5660/5680 Yes
This command is supported on distributed devices and IRF-capable centralized devices.
Specify traffic processing slots if a feature requires that all traffic on an HDLC link bundle interface be
processed on the same slot.
For high availability, you can specify one primary and one backup traffic processing slot by using
the service command and the service standby command, respectively.
To avoid processing slot switchover, specify the primary slot before specifying the backup slot. If you
specify the backup slot before specifying the primary slot, traffic is switched over to the primary slot
immediately after you specify the primary slot.
If you specify both primary and backup slots for an interface, traffic on that interface is processed as
follows:
The backup slot takes over when the primary slot becomes unavailable. The backup slot
continues to process traffic for the interface after the primary slot becomes available again. The
switchover will not occur until the backup slot becomes unavailable.
When no specified traffic processing slots are available, the traffic is processed on the slot at
which it arrives. Then, the processing slot that first becomes available again takes over.
If you do not specify a primary or a backup traffic processing slot for an i nterface, traffic on that
interface is processed on the slot at which the traffic arrives.
Examples
# (Distributed devices in standalone mode.) Specify a primary traffic processing slot and a backup
traffic processing slot for HDLC link bundle interface 1.
<Sysname> system-view
[Sysname] interface hdlc-bundle 1
[Sysname--HDLC-bundle1] service slot 2
[Sysname- HDLC-bundle1] service standby slot 3
Related commands
service
shutdown
Use shutdown to shut down an HDLC link bundle interface.
Use undo shutdown to bring up an HDLC link bundle interface.
Syntax
shutdown
undo shutdown
Default
An HDLC link bundle interface is up.
Views
HDLC link bundle interface view

Table of Contents

Other manuals for H3C MSR810

Related product manuals