H3C MSR810 - Fr Compression Iphc Enable

332
Field
Description
Creation time: 2012/1/04/01 23:55:39, Status: Active
Time when the PVC was created and the state of the
PVC, which can be
Active
or
Inactive
.
Input: 0 packets, 0 bytes, 0 dropped
Number of received packets, number of received
bytes, and number of dropped packets.
Output: 0 packets, 0 bytes, 0 dropped
Number of sent packets, number of sent bytes, and
number of dropped packets.
DE list: 3 DE set packets: 0
DE list number and number of packets with the DE
bit set.
Traffic policing: Inactive
Status of traffic policing:
• Active.
• Inactive.
Input : 0 packets, 0 bytes, 0 dropped, 0 set DE
packets
Number of received packets, number of received
bytes, number of dropped packets, and number of
packets with the DE bit set.
Traffic shaping: Inactive
Status of traffic shaping:
• Active.
• Inactive.
Output: 0 packets, 0 bytes, 0 dropped packets
Number of sent packets, number of sent bytes, and
number of dropped packets after traffic shaping is
enabled.
Delayed: 0 packets, 0 bytes
Number of outgoing packets delayed and number of
outgoing bytes delayed.
Related commands
broadcast
fr dlci
fr encapsulation
fr interface-type
fr map ip
reset fr pvc
fr compression iphc enable
Use fr compression iphc enable to enable Frame Relay IPHC on a Frame Relay interface or VC.
Use undo fr compression iphc enable to disable Frame Relay IPHC on a Frame Relay interface or
VC.
Syntax
fr compression iphc enable [ nonstandard ]
undo fr compression iphc enable
Default
Frame Relay IPHC is disabled.
Views
Interface view
Frame Relay virtual circuit view