H3C MSR810 - Display Interface Dialer

306
Table 57 Command output
Field
Description
Dialer0 Dialup interface: dialer or physical.
Dialer Route:
NextHop: 111.111.111.111 Dialer
number:
123456789012345678901234567890
Remote IP address and dial string set by using the
dialer route
command.
Dialer number Dial string for a remote IP address.
Dialer Timers(in seconds):
Auto-dial: 300 Compete: 20
Enable: 5
Idle: 120 Wait-for-Carrier: 60
DDR timers in seconds:
• Auto-dial—Auto-dial timer set by the dialer timer autodial
command.
• Compete—Compete-idle timer set by the dialer timer
compete command.
• Enable—Link holddown timer set by the dialer timer enable
command.
• Idle—Link idle-timeout timer set by the dialer timer idle
command.
• Wait-for-Carrier—Wait-carrier timer set by the dialer timer
wait-carrier command.
Total Channels
Total number of physical interfaces on the interface. For an ISDN
interface, it refers to the number of B channels.
Free Channels Number of free channels.
display interface dialer
Use display interface dialer to display information about a dialer interface.
Syntax
display interface [ dialer [ interface-number ] ] [ brief [ description | down ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a dialer interface by its number.
brief: Displays brief interface information. If you do not specify this keyword, the command displays
detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, the
command displays only the first 27 characters of each interface description.
down: Displays information about interfaces in physically down state and the causes. If you do not
specify this keyword, the command displays information about interfaces in all states.
Usage guidelines
If you do not specify the dialer keyword, this command displays information about all interfaces on
the device.
If you specify the dialer keyword, this command displays information about all dialer interfaces.