354
Multilink Frame Relay commands
This feature is supported only on Layer 2 Ethernet ports on the following modules:
• CE3.
• CPOS.
• CT3.
• E1.
• E1-F.
• POS.
• SAE.
• T1.
• T1-F.
bandwidth
Use bandwidth to set the expected bandwidth for an MFR interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) for an MFR interface is the interface baud rate divided by 1000.
Views
MFR interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an i nformational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth to 1000 kbps for interface MFR 0/0/2.
<Sysname> system-view
[Sysname] interface mfr 0/0/2
[Sysname-MFR0/0/2] bandwidth 1000
default
Use default to restore the default settings for an MFR interface.
To Next Page
Loading...
