H3C MSR810 - Fr Lmi Type; Fr Map

347
fr lmi type
Use fr lmi type to configure the Frame Relay LMI protocol type.
Use undo fr lmi type to restore the default.
Syntax
fr lmi type { ansi | nonstandard | q933a }
undo fr lmi type
Default
The Frame Relay LMI protocol type is q933a.
Views
Interface view
Predefined user roles
network-admin
Parameters
ansi: Specifies the standard LMI protocol defined in ANSI T1.617 Annex D.
nonstandard: Specifies the nonstandard compatible LMI protocol.
q933a: Specifies the standard LMI protocol defined in Q.933 Annex A.
Usage guidelines
The LMI protocol maintains the Frame Relay PVC table. It can perform the following operations:
• Notifies the addition of a PVC.
• Detects the deletion of a PVC.
• Monitors PVC status changes.
• Verifies link integrity.
The system usually supports the following LMI protocols:
• ITU-T Q.933 Annex A.
• ANSI T1.617 Annex D.
• Nonstandard compatible LMI protocol.
Examples
# Configure the Frame Relay LMI type as nonstandard compatible protocol on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr lmi type nonstandard
fr map
Use fr map to create a static address-to-DLCI map.
Use undo fr map to delete a static address-to-DLCI map.
Syntax
fr map ip { ip-address | default } dlci-number
fr map ipv6 { ipv6-address | default } dlci-number
undo fr map ip { ip-address | default } dlci-number