H3C MSR810 - PPP and MP Commands; PPP Commands; Display Ip Pool

1
PPP and MP commands
This feature is supported only on Layer 2 Ethernet ports on the following modules:
• AM.
• AS.
• ASE.
• BS.
• CE3.
• CPOS.
• E1.
• E1-F.
• POS.
• SAE.
• T1.
• T1-F.
Commands and descriptions for centralized devices apply to the following routers:
• MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-L
MS/810-LUS.
• MSR2600-10-X1.
• MSR 2630.
• MSR3600-28/3600-51.
• MSR3600-28-SI/3600-51-SI.
• MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC.
• MSR 3610/3620/3620-DP/3640/3660.
Commands and descriptions for distributed devices apply to the following routers:
• MSR5620.
• MSR 5660.
• MSR 5680.
IPv6-related parameters are not supported on the following routers:
• MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-L
MS/810-LUS.
• MSR3600-28-SI/3600-51-SI.
PPP commands
display ip pool
Use display ip pool to display PPP address pools.
Syntax
display ip pool [ pool-name ] [ group group-name ]