281
Syntax
interface eth-channel interface-number
Views
System view
Predefined user roles
network-admin
Parameters
interface-number: Specifies an Eth-channel interface by its number.
Examples
# Enter Eth-channel 2/4/0:0 interface view.
<Sysname> system-view
[Sysname] interface eth-channel 2/4/0:0
[Sysname-Eth-channel2/4/0:0]
ip address cellular-alloc
Use ip address cellular-alloc to enable an Eth-channel interface to obtain an IP address by using
the modem-manufacturer's proprietary protocol.
Use undo ip address cellular-alloc to restore the default.
Syntax
ip address cellular-alloc
undo ip address cellular-alloc
Default
An Eth-channel interface does not obtain an I P address by using the modem-manufacturer's
proprietary protocol.
Views
Eth-channel interface view
Predefined user roles
network-admin
Usage guidelines
To enable an interface to obtain an IP address from the modem by using the modem-manufacturer's
proprietary protocol, use the ip address cellular-alloc command.
To enable an interface to obtain an IP address from the modem by using DHCP, use the ip address
dhcp-alloc command.
The IP address of the modem is automatically allocated by the service provider.
Examples
# Channelize Cellular 2/4/0 into an Eth-channel interface. Enable the Eth-channel interface to obtain
an IP address by using the modem-manufacturer's proprietary protocol.
<Sysname> system-view
[Sysname] controller cellular 2/4/0
[Sysname-Cellular2/4/0] eth-channel 0
[Sysname-Cellular2/4/0] quit
[Sysname] interface eth-channel 2/4/0:0
To Next Page
Loading...
