H3C MSR810 - Dialer Timer Wait-Carrier; Dialer Timer Warmup

302
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer timer idle 50
dialer timer wait-carrier
Use dialer timer wait-carrier to set the wait-carrier timer.
Use undo dialer timer wait-carrier to restore the default.
Syntax
dialer timer wait-carrier wait-carrier
undo dialer timer wait-carrier
Default
The wait-carrier timer is 60 seconds.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
wait-carrier: Specifies the wait-carrier timer value in the range of 0 to 65535 seconds.
Usage guidelines
The wait-carrier timer limits the amount of time that DDR waits for a connection to be established for
a call. The wait-carrier timer starts when a call is placed. If the connection is not established before
the timer expires, DDR terminates the call.
Examples
# Set the wait-carrier timer to 100 seconds on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer timer wait-carrier 100
dialer timer warmup
Use dialer timer warmup to set the warm-up timer for dynamic route backup.
Use undo dialer timer warmup to restore the default.
Syntax
dialer timer warmup delay
undo dialer timer warmup
Default
The warm-up timer for dynamic route backup is 30 seconds.
Views
System view
Predefined user roles
network-admin