H3C MSR810 - Ppp Mp Lfi Size-Per-Frag

52
Views
VT interface view
Dialer interface view
MP-group interface view
Predefined user roles
network-admin
Usage guidelines
Disabling LFI also removes the user-configured settings of the maximum LFI fragment transmission
delay and size.
Examples
# Enable LFI on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp lfi enable
Related commands
ppp mp lfi delay-per-frag
ppp mp lfi size-per-frag
ppp mp lfi size-per-frag
Use ppp mp lfi size-per-frag to set the maximum LFI fragment size (in bytes) on an interface.
Use undo ppp mp lfi size-per-frag to restore the default.
Syntax
ppp mp lfi size-per-frag size
undo ppp mp lfi size-per-frag
Default
On an interface, the maximum LFI fragment size is derived from this formula: (Expected bandwidth
of the interface x Maximum LFI fragment transmission delay)/8.
Views
VT interface view
Dialer interface view
MP-group interface view
Predefined user roles
network-admin
Parameters
size: Specifies the maximum LFI fragment size in the range of 40 to 1500 bytes.
Usage guidelines
When LFI is enabled and bot h this command and the ppp mp lfi delay-per-frag command are
configured, the maximum LFI fragment size is the value configured with the ppp mp lfi size-per-frag
command.