H3C MSR810 - ISDN Commands; Display Isdn Active-Channel

154
ISDN commands
This feature is supported only on routers installed with the BS, E1, or T1 interface modules.
Before you can use a CE1/PRI or CT1/PRI interface to provide ISDN PRI services, you must use
the pri-set command to bundle timeslots into channel sets on the interface. For each PRI set, the
system creates a serial interface automatically. To configure ISDN settings for a PRI set, you must
enter the view of this serial interface.
For more information about timeslot bundling, see the WAN interface section in Interface
Configuration Guide.
display isdn active-channel
Use display isdn active-channel to display information about successful calls on ISDN interfaces.
Syntax
display isdn active-channel [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an ISDN BRI or PRI interface by its type and
number. If you do not specify an interface, the command displays information about successful calls
for all ISDN interfaces.
Examples
# Display information about successful Q.931 calls on BRI 2/4/0.
<Sysname> display isdn active-channel interface bri 2/4/0
Bri 2/4/0
Channel Info: B1
Call Property: Analog
Call Type: Out
Calling Number: 1111
Calling Subaddress:
Called Number: 2222
Called Subaddress:
Start Time: 13-03-14 15:22:26
Time Used: 00:01:10
# Display information about successful Q.931 calls on PRI interface Serial 2/3/0:15.
<Sysname> display isdn active-channel interface serial 2/3/0:15
Serial2/3/0:15
Serial2/3/0:15
Channel Info: B2
Call Property: Digital
Call Type: Out