123
service standby
Use service standby to specify a backup traffic processing slot for an interface.
Use undo service standby to restore the default.
Syntax
Distributed devices in standalone mode:
service standby slot slot-number
undo service standby slot
Default
No backup traffic processing slot is specified for an interface.
Views
Virtual PPP interface view
Default command level
network-admin
Parameters
slot slot-number: Specifies a card by its slot number. (Distributed devices in standalone mode.)
Usage guidelines
The following matrix shows the command and hardware compatibility:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE
/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS
No
MSR2600-10-X1 No
MSR 2630 Yes
MSR3600-28/3600-51 Yes
MSR3600-28-SI/3600-51-SI No
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC Yes
MSR 3610/3620/3620-DP/3640/3660 Yes
MSR5620/5660/5680 Yes
This command affects only L2TP data messages. The control messages are always processed on
the active MPU.
Specify traffic processing slots if a f eature requires that all traffic on a v irtual PPP interface be
processed on the same slot.
For high availability, you can specify one primary and one backup traffic processing slot by using
the service command and the service standby command, respectively.
To avoid processing slot switchover, specify the primary slot before specifying the backup slot. If you
specify the backup slot before specifying the primary slot, traffic is switched over to the primary slot
immediately after you specify the primary slot.
If you specify both primary and backup slots for an interface, traffic on that interface is processed as
follows:
To Next Page
Loading...
