H3C MSR810 - Display Pppoe-Server Throttled-Mac

70
Field
Description
Local PPPoE sessions on slot slot-number
Total number of PPPoE sessions on the local card's
physical interfaces (distributed devices in standalone
mode).
When an interface is specified, this field is not displayed.
Ethernet interface Interface where the PPPoE session is present.
Session ID PPPoE session ID.
PPP interface Virtual access interface created for the PPPoE session.
State
PPPoE session state:
• PADR RCVD—The PPPoE session is being
negotiated.
• Open—The PPPoE session has been successfully
established.
RemoteMAC MAC address of the remote end.
LocalMAC MAC address of the local end.
Service VLAN
Service provider VLAN.
N/A
means no service provider VLAN is available.
Customer VLAN
Customer VLAN.
N/A
means no customer VLAN is available.
display pppoe-server throttled-mac
Use display pppoe-server throttled-mac to display information about blocked users.
Syntax
Centralized devices in standalone mode:
display pppoe-server throttled-mac [ interface interface-type interface-number ]
Distributed devices in standalone mode:
display pppoe-server throttled-mac { slot slot-number
| interface interface-type interface-number }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface for centralized devices in standalone mode,, the command displays
information about blocked users on all interfaces.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, the command
displays information about blocked users on all cards. (Distributed devices in standalone mode.)
Examples
# Display information about blocked users on GigabitEthernet 1/0/1.
<Sysname> display pppoe-server throttled-mac interface gigabitethernet 1/0/1