H3C MSR810 - Dialer Circular Enable

291
Default
Calls from all ISDN calling numbers are accepted, and callback is not initiated.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
remote-number: Specifies an ISDN calling number, a case-insensitive string of 1 to 30 characters.
The asterisk (*) is allowed as a wildcard that matches any character.
callback: Enables callback for the specified ISDN calling number.
Usage guidelines
A dialup interface screens an i ncoming call by comparing the calling number with the numbers
configured in the dialer call-in command. If the remote SPCS does not provide the calling number,
the call is dropped directly.
On a dialup interface configured with the dialer call-in callback command, you must configure the
dialer route or dialer number command. The dial-number configured in the dialer route or dialer
number command must be the same as the remote-number configured in the dialer call-in
callback command.
Examples
# Configure BRI 2/4/0 to place return calls for ISDN calling number 8810152.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] dialer route ip 100.1.1.2 8810152
[Sysname-Bri2/4/0] dialer call-in 8810152 callback
Related commands
dialer callback-center
dialer circular enable
Use dialer circular enable to enable traditional DDR on a dialup interface.
Use undo circular bundle enable to disable traditional DDR on a dialup interface.
Syntax
dialer circular enable
undo dialer circular enable
Default
Traditional DDR is disabled on a dialup interface.
Views
Dialup interface view
Predefined user roles
network-admin
Usage guidelines
DDR includes traditional DDR and bundle DDR.