232
Modem encoding format varies by countries. Use this command to set the modem encoding format
for a country.
Examples
# Set the country code to china on AM interface 2/4/0.
<Sysname> system-view
[Sysname] interface analogmodem 2/4/0
[Sysname-Analogmodem2/4/0] country-code china
modem answer-timer
Use modem answer-timer to set a dial-up connection timer.
Use undo modem answer-timer to restore the default.
Syntax
modem answer-timer time
undo modem answer-timer
Default
The dial-up connection timer is 60 seconds.
Views
User line view
Predefined user roles
network-admin
Parameters
time: Sets the dial-up connection timer in the range of 1 to 65535, in seconds.
Usage guidelines
When the timer expires, the modem disconnects the call.
• If the modem is on the calling party side, the timer starts when the modem starts to dial.
• If the modem is on the called party side, the timer starts when the modem goes off hook.
This command is available on the following user lines:
• TTY lines for the following interfaces:
AM interface
Asynchronous serial interface
Asynchronous/synchronous serial interface operating in asynchronous mode
• AUX line
This command is not available on the console or VTY lines.
To display the user line for an interface, use the display line command.
Examples
# Set the dial-up connection timer to 50 seconds.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] modem answer-timer 50
To Next Page
Loading...
