H3C MSR810 - Fr Interface-Type; Fr Ipv6 Ind

341
Examples
# Set the InARP request interval during an I nARP learning process to 15 seconds on the Frame
Relay interface Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr inarp interval 15
Related commands
display fr inarp
fr inarp
fr interface-type
Use fr interface-type to set the type of a Frame Relay interface.
Use undo fr interface-type to restore the default.
Syntax
fr interface-type { dce | dte }
undo fr interface-type
Default
The type of a Frame Relay interface is DTE.
Views
Interface view
Predefined user roles
network-admin
Parameters
dce: Specifies DCE.
dte: Specifies DTE.
Examples
# Set the type of the Frame Relay interface Serial 2/1/0 to DCE.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr interface-type dce
fr ipv6 ind
Use fr ipv6 ind to enable IND for dynamic address mapping on a Frame Relay interface.
Use undo fr ipv6 ind to disable IND for dynamic address mapping on a Frame Relay interface.
Syntax
fr ipv6 ind [ dlci-number ]
undo fr ipv6 ind [ dlci-number ]
Default
IND is disabled on a Frame Relay interface.