351
<Sysname> reset fr compression iphc
Related commands
display fr compression iphc
reset fr inarp
Use reset fr inarp to clear dynamic address-to-DLCI maps established by InA R P.
Syntax
reset fr inarp [ interface interface-type interface-number [ dlci dlci-number ] ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main interface or subinterface. If you specify a main interface, this command clears information for
the main interface and its subinterfaces. If you specify a subinterface, this command clears
information for the subinterface. If you do not specify an interface, this command clears information
for all interfaces.
dlci dlci-number: Specifies a VC by its DLCI in the range of 16 to 1007. DLCIs 0 through 15 and 1008
through 1023 are reserved. If you specify a VC, this command clears the dynamic address-to-DLCI
map of the VC.
Usage guidelines
In some situations, for example, when the network topology changes, the dynamic address-to-DLCI
maps will become invalid. Before dynamic address-to-DLCI maps are established again, clear all
dynamic address-to-DLCI maps.
Examples
# Clear all dynamic IPv4 address-to-DLCI maps.
<Sysname> reset fr inarp
Related commands
fr inarp
reset fr ipv6 ind
Use reset fr ipv6 ind to clear dynamic IPv6 address-to-DLCI maps.
Syntax
reset fr ipv6 ind [ interface interface-type interface-number [ dlci dlci-number ] ]
Views
User view
Predefined user roles
network-admin
To Next Page
Loading...
